Re: NANFA-L-- I need help guys


Subject: Re: NANFA-L-- I need help guys
Moontanman-in-aol.com
Date: Tue Aug 10 2004 - 23:09:41 CDT


In a message dated 8/10/04 11:58:58 PM Eastern Daylight Time, rjs-in-silcom.com
writes:

> Moon:
>
> Unless you come up with a better solution, you might try a simple set-up
> with a very small pulley on the motor shaft and a much larger one on
> the driven end. Seems to me that would do it, once you get the proper
> relationship sorted out - small pulley to big one.
>
> Bob
>
>

I've been thinking along those lines but what is the relation ship between
the out put and the drive gear? If the motor is turning-in-2000 rpm now big
would the two gears have to be to get me 10 rpm-in-my filter barrel? I do have a
small motor from a piston air pump but it turns somewhere around 2000 rpm.

Moon

/-----------------------------------------------------------------------
/ This is the discussion list of the North American Native Fishes
/ Association (NANFA). Comments made on this list do not necessarily
/ reflect the beliefs or goals of NANFA. For more information about NANFA,
/ visit http://www.nanfa.org . Please make sure all posts to nanfa-l are
/ consistent with the guidelines as per
/ http://www.nanfa.org/archive/nanfa/guidelines.html. To subscribe,
/ unsubscribe, or get help, visit the NANFA email list home page and
/ archive-in-http://www.nanfa.org/archive/nanfa/.



: Wed Sep 29 2004 - 12:24:18 CDT