RE: NANFA-L-- I need help guys


Subject: RE: NANFA-L-- I need help guys
From: Bob Sinclair (rjs-in-silcom.com)
Date: Tue Aug 10 2004 - 23:32:45 CDT


Moon:

Sorry, can't help. I'm sure there's a simple equation available,
but I don't know where to find it.

Bob
  -----Original Message-----
  From: owner-nanfa-l-in-nanfa.org
Moontanman-in-aol.com
  Sent: Tuesday, August 10, 2004 9:10 PM
  To: nanfa-l-in-nanfa.org
  Subject: Re: NANFA-L-- I need help guys

  In a message dated 8/10/04 11:58:58 PM Eastern Daylight Time,
rjs-in-silcom.com writes:

    Moon:

    Unless you come up with a better solution, you might try a simple set-up
    with a very small pulley on the motor shaft and a much larger one on
    the driven end. Seems to me that would do it, once you get the proper
    relationship sorted out - small pulley to big one.

    Bob

  I've been thinking along those lines but what is the relation ship between
the out put and the drive gear? If the motor is turning-in-2000 rpm now big
would the two gears have to be to get me 10 rpm-in-my filter barrel? I do
have a small motor from a piston air pump but it turns somewhere around 2000
rpm.

  Moon

/-----------------------------------------------------------------------
/ This is the discussion list of the North American Native Fishes
/ Association (NANFA). Comments made on this list do not necessarily
/ reflect the beliefs or goals of NANFA. For more information about NANFA,
/ visit http://www.nanfa.org . Please make sure all posts to nanfa-l are
/ consistent with the guidelines as per
/ http://www.nanfa.org/archive/nanfa/guidelines.html. To subscribe,
/ unsubscribe, or get help, visit the NANFA email list home page and
/ archive-in-http://www.nanfa.org/archive/nanfa/.



: Wed Sep 29 2004 - 12:24:18 CDT